tc-pie(8) - phpMan

Command: man perldoc info search(apropos)  


PIE(8)                                        Linux                                        PIE(8)

NAME
       PIE - Proportional Integral controller-Enhanced AQM algorithm

SYNOPSIS
       tc  qdisc  ... pie [ limit PACKETS ] [ target TIME ] [ tupdate TIME ] [ alpha int ] [ beta
       int ] [ ecn | noecn ] [ bytemode | nobytemode ] [ dq_rate_estimator | no_dq_rate_estimator
       ]

DESCRIPTION
       Proportional  Integral  controller-Enhanced (PIE) is a control theoretic active queue man-
       agement scheme. It is based on the proportional integral controller but  aims  to  control
       delay. The main design goals are
        o Low latency control
        o High link utilization
        o Simple implementation
        o Guaranteed stability and fast responsiveness

ALGORITHM
       PIE  is designed to control delay effectively. First, an average dequeue rate is estimated
       based on the standing queue. The rate is used to calculate the current delay. Then,  on  a
       periodic  basis,  the  delay is used to calculate the dropping probabilty. Finally, on ar-
       rival, a packet is dropped (or marked) based on this probability.

       PIE makes adjustments to the probability based on the trend of the delay i.e.  whether  it
       is going up or down.The delay converges quickly to the target value specified.

       alpha  and  beta  are  statically chosen parameters chosen to control the drop probability
       growth and are determined through control theoretic approaches. alpha determines  how  the
       deviation  between  the  current and target latency changes probability. beta exerts addi-
       tional adjustments depending on the latency trend.

       The drop probabilty is used to mark packets in ecn mode. However, as in  RED,  beyond  10%
       packets  are  dropped based on this probability. The bytemode is used to drop packets pro-
       portional to the packet size.

       Additional details can be found in the paper cited below.

PARAMETERS
   limit
       limit on the queue size in packets. Incoming  packets  are  dropped  when  this  limit  is
       reached. Default is 1000 packets.

   target
       is the expected queue delay. The default target delay is 15ms.

   tupdate
       is the frequency at which the system drop probability is calculated. The default is 15ms.

   alpha
   beta
       alpha  and  beta are parameters chosen to control the drop probability. These should be in
       the range between 0 and 32.

   ecn | noecn
       is used to mark packets instead of dropping.  ecn to turn on ecn mode, noecn to  turn  off
       ecn mode. By default, ecn is turned off.

   bytemode | nobytemode
       is  used to scale drop probability proportional to packet size.  bytemode to turn on byte-
       mode, nobytemode to turn off bytemode. By default, bytemode is turned off.

   dq_rate_estimator | no_dq_rate_estimator
       is used to calculate delay using Little's law.  dq_rate_estimator to turn on dq_rate_esti-
       mator,  no_dq_rate_estimator to turn off no_dq_rate_estimator. By default, dq_rate_estima-
       tor is turned off.

EXAMPLES
        # tc qdisc add dev eth0 root pie
        # tc -s qdisc show
          qdisc pie 8036: dev eth0 root refcnt 2 limit 1000p target 15.0ms tupdate 16.0ms alpha 2
       beta 20
           Sent 31216108 bytes 20800 pkt (dropped 80, overlimits 0 requeues 0)
           backlog 16654b 11p requeues 0
            prob 0.006161 delay 15666us
            pkts_in 20811 overlimit 0 dropped 80 maxq 50 ecn_mark 0

        # tc qdisc add dev eth0 root pie dq_rate_estimator
        # tc -s qdisc show
          qdisc pie 8036: dev eth0 root refcnt 2 limit 1000p target 15.0ms tupdate 16.0ms alpha 2
       beta 20
           Sent 63947420 bytes 42414 pkt (dropped 41, overlimits 0 requeues 0)
           backlog 271006b 179p requeues 0
            prob 0.000092 delay 22200us avg_dq_rate 12145996
            pkts_in 41 overlimit 343 dropped 0 maxq 50 ecn_mark 0

        # tc qdisc add dev eth0 root pie limit 100 target 20ms tupdate 30ms ecn
        # tc -s qdisc show
          qdisc pie 8036: dev eth0 root refcnt 2 limit 100p target 20.0ms tupdate 32.0ms alpha  2
       beta 20 ecn
           Sent 6591724 bytes 4442 pkt (dropped 27, overlimits 0 requeues 0)
           backlog 18168b 12p requeues 0
            prob 0.008845 delay 11348us
            pkts_in 4454 overlimit 0 dropped 27 maxq 65 ecn_mark 0

        # tc qdisc add dev eth0 root pie limit 100 target 50ms tupdate 30ms bytemode
        # tc -s qdisc show
          qdisc  pie 8036: dev eth0 root refcnt 2 limit 100p target 50.0ms tupdate 32.0ms alpha 2
       beta 20 bytemode
           Sent 1616274 bytes 1137 pkt (dropped 0, overlimits 0 requeues 0)
           backlog 13626b 9p requeues 0
            prob 0.000000 delay 0us
            pkts_in 1146 overlimit 0 dropped 0 maxq 23 ecn_mark 0

SEE ALSO
       tc(8), tc-codel(8) tc-red(8)

SOURCES
        o RFC 8033: https://tools.ietf.org/html/rfc8033

AUTHORS
       PIE was implemented by Vijay Subramanian and Mythili Prabhu, also the authors of this  man
       page.  Please report bugs and corrections to the Linux networking development mailing list
       at <netdev AT vger.org>.

iproute2                                 16 January 2014                                   PIE(8)

Generated by $Id: phpMan.php,v 4.55 2007/09/05 04:42:51 chedong Exp $ Author: Che Dong
On Apache
Under GNU General Public License
2024-04-19 18:38 @3.140.186.241 CrawledBy Mozilla/5.0 AppleWebKit/537.36 (KHTML, like Gecko; compatible; ClaudeBot/1.0; +claudebot@anthropic.com)
Valid XHTML 1.0!Valid CSS!